MakerWorld
Sport & Outdoors
Go to Model
Brace Hinge V2
443
Downloads
205
Likes
219
Makes
This is a re design of my original this one utilizes M3 nuts instead of brass inserts. It is also optimized for strength. BOM 2 M3x12MM SHCS (These will replace the two original M3x8 SHCS that connect the hinge to the Pica-tinny Mount) 2 M3 Hex Nuts (Im using Nylock nuts, but either should work.) 1 M4X30 SHCS 1 M4 Hex Nut (Im using Nylock nut, but either should work) 1 8MM OD X 20MM Long Light load 3D Printer Die Spring Everything is basically the same as the original except this one is stronger, uses hex nuts, and needs little bit longer screws.
WrenchWorks3D also publishes on
55 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
