Thingiverse
Bracelet Rack
by smorgana
32
Downloads
21
Likes
0
Makes
Print one rack, 4 rods, and 8 end caps.
I used epoxy glue to glue the parts together.
you may need to sand the ends of the rods to fit them into the end caps.
All parts print on an Ultimaker 2+ without supports.
I used epoxy glue to glue the parts together.
you may need to sand the ends of the rods to fit them into the end caps.
All parts print on an Ultimaker 2+ without supports.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
