Thingiverse
Bracket 59mm and hinge
door cruzer619
1
Downloads
0
Likes
0
Makes
Love this pi mount but needed to go back a little more and wanted to angle it out some too. So I made this remix. Need m3 x 20mm bolt and m3 nut for top hinge.. and just slid filament on the bottom hinge. Only need to tighten the top to keep the angle. I also added in a cable chain slot. Hope it helps someone.
cruzer619 publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!