Brackets and Pegs for 3D printable Rack

A collection of brackets and M5 pegs to expand and reinforce your 3D printable rack system. This model is part of a series of accessories for my 3D printable rack system. You can check the other models here: 6-inch rack accessories. 10-inch rack accessories. Do you like my models? Consider buying me a coffee ;) Assembly instructions Pegs You can use the M5 3D printable pegs to join two rails together and make a taller rack. You will need one peg for every pair or rails. To install it, follow the instructions below. Insert the peg into one of the rail M5 holes. Push the other rail against the other end of the peg. Then press the rails against each other until the peg is fully inserted on both. Make sure everything is correctly aligned. For better results, also use the 3D printed brackets. Brackets The brackets can be used to reinforce the connection between rails. To install them, please follow the instructions below. Align both rails, and place the bracket on top of them. Insert 2x M5x20mm screws in the bracket. And also insert 2x M5 hex nuts on the back of the rails. Fully insert the M5 screws, and you're done! Print Settings Rafts: Doesn't Matter. Supports: No. Walls/Perimeters: At least 3. Resolution: 0.2 or 0.24 Infill: 25% or more Filament: Any rigid filament.