Thingiverse
Braun razor holder
by blueagle
5
Downloads
1
Likes
0
Makes
It is a remake of a Braun electric razor holder that had to be attached to the wall, I just wanted to be standing.
it is. simple and effective.
you need supports to print it.
run the print in the evening so the morning after you will have it ready, it takes on average 8 hours to be printed, but it is worth.
just a couple of suggestion:
- whatever material you use do not use the fan, it increase the layer adhesion
- print hotter than usual to improve layer adhesion
- use a little of brim to be sure it doesn't detach it happened to me the first time.
as usual enjoy.
it is. simple and effective.
you need supports to print it.
run the print in the evening so the morning after you will have it ready, it takes on average 8 hours to be printed, but it is worth.
just a couple of suggestion:
- whatever material you use do not use the fan, it increase the layer adhesion
- print hotter than usual to improve layer adhesion
- use a little of brim to be sure it doesn't detach it happened to me the first time.
as usual enjoy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
