Break Apart Titanic

Edit 10-21-2025: I added another print plate and STL file with a looser connection receiver hole. I hope this helps. Kawa made such a great model and my nephews were dying for a break apart Titanic so I added a pull apart feature. The connector tab is a bit tight at first so I recommend rubbing a little dry bar soap on it and it should slip right in and out. I purposely left it tight so the pieces didn't separate when carried by one end, allowing the bottom piece slip to the floor and break. Hope you enjoy as much as my nephews do. Please note: This model has not been tested for the coefficient of floaty-ness vs sinky-ness but it has been nephew approved for general use boat-y disaster playtime. FOR THOSE WITHOUT AMS, the layers are as follows:Red - Layers 1-60 Black - Layers 61-91Gold/Yellow - Layers 92-95White - Layers 96-141Gold/Yellow - Layers 142-191Black - Layers 191-end There will be a small area on the deck where the gold/yellow gets onto the lifeboats and other small areas