Thingiverse
Break-away BLTouch Mount
door JamesK1
26
Downloads
12
Likes
0
Makes
This is just for the BLTouch mount that I made for the Hemera Part Cooling Duct by Hangtight. I designed it so it'll bend or break away if it gets snagged by a bad print rather than breaking the BLTouch (which has happened to me unfortunately).
You'll need one 2.5mmx8mm screw to mount it onto the Duct Mount Plate. And two 3mmx6mm screw for the BLTouch.
I've also included the Duct Mount Plate which I only added the screw hole for this mount. You could just use a 2mm or 5/64" drill bit, which is what I did, to create the hole on an existing mount.
These are the offsets you'll need to add to your firmware: X61 Y-31.5
And of course the Z offset will be specific to your setup.
You'll need one 2.5mmx8mm screw to mount it onto the Duct Mount Plate. And two 3mmx6mm screw for the BLTouch.
I've also included the Duct Mount Plate which I only added the screw hole for this mount. You could just use a 2mm or 5/64" drill bit, which is what I did, to create the hole on an existing mount.
These are the offsets you'll need to add to your firmware: X61 Y-31.5
And of course the Z offset will be specific to your setup.
JamesK1 publiceert ook op
44 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
