Thingiverse
Breakaway Clasp
von MasterCommander
385
Downloads
259
Likes
1
Makes
This was designed for 550 paracord. To use, gut the last couple of inches of the paracord and tie it in a knot so the clasp will stay on. If the paracord is not gutted the knot will be too big to fit in the clasp.
It takes roughly 20 lbs of force to separate the two pieces so it won't just pop loose randomly but will if you need it too.
Printed in ABS and PLA. Use either a raft or brim to increase bed adhesion.
**V2**
Increased the inner clasp thickness to prevent the tabs from breaking off as easily.
**V3**
Scaled down the inner by 4% to loosen the connection.
It takes roughly 20 lbs of force to separate the two pieces so it won't just pop loose randomly but will if you need it too.
Printed in ABS and PLA. Use either a raft or brim to increase bed adhesion.
**V2**
Increased the inner clasp thickness to prevent the tabs from breaking off as easily.
**V3**
Scaled down the inner by 4% to loosen the connection.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
