Breastmilk Freeze Flat

This is a freeze flat for breastmilk bags. The design utilizes two Velcro straps (I got them from Walmart) to secure the lid down and has leveling marks to aid in obtaining as close to flat of a bag as possible. I did increase the infill of the middle section on the base once it starts to leave the main base to about 70% to help with the strength otherwise the rest was done with a 20% infill. If your printer has a little bit of over extrusion on the first layer you may have to trim the edge with a razor to take off the bur to allow for better fitment. This Design is not allowed to be resold just enjoyed by the 3D printing/pumping community.