MakerWorld
Creatures
Go to Model
Brick Pyroraptor
89
Downloads
107
Likes
77
Makes
Brick pyroraptor 1:1 scale. Use care when removing supports! When assembling, if you use too much force, you will break the jaw! If your print tolerances are too tight, try increasing/decreasing the jaw piece. OR if you already have it printed, try using gentle heat, such as a heatgun (from a few inches away) to warm the plastic, then assemble. Using too much heat will melt your plastic.
maker_rachael also publishes on
17 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
