BrickHeadz Wall Mount Display

I've been wanting to display my L3go BrickHeadz in a wall mount setting as I was tired of them sliding around on shelves. So I came up with this little handy dandy design to display them on the wall using a simple 3 or 5 lbs Command Strip cut in half and applied to the back. It can be printed in either PLA or PETG, but I would suggest PETG for the strength. No supports required but allow to fully cool before removing from print bed to avoid warping.This design has been tested on multiple different BrickHeadz but will only accept the standard square BrickHeadz base plate design.