Bridge support / pillar with ramp

A bridge support/pillar for brio compatible tracks. Width is 4cm so it fits the track tight in order to have better stability (I was struggling with other available bridge pillars to be quite wobbly). Sadly, this means kids will have to use a bit of force - thats where dense infill comes handy ;-) Still, none of the pillars broke so far. Will fit taller thomas&co trains.

The pillar was printed using PLA (10% adaptive infill) on Prusa i3 without supports quite nicely.

Ramp was rotated 90deg with snug supports and 10% infill. It is possible to use Ikea's ramps - eventhough they are made for smaller bridges.