Brio compatible hotwheels wagon, fully printed

by LayerCraftCreation · Other Toys & Games

561 Downloads

228 Likes

349 Makes

New version with print-in-place moveable clutch available: https://makerworld.com/de/models/1048880#profileId-1035190Boost MeSupport me with a boost for more designs :)Finally i finished my design for the brio compatible car wagon. It can survice the “bridge test” - means the car will stand in place while the train moves over a bridge. Its fully printed and takes about 30 minutes for the single color variant. The second build plate offers the dual color option (only 1 color change). There are slots for 10x2mm magnets. Its sitting very tight but you can attach glue on the magnets to ensure the kids cannot remove it.Else the magnets can be pushed out through a small whole on the bottom. Also check out my DUPLOMOBIL (with duplo attachement) Tip: when you attach a magnet to a cars roof it can be picked up by crane, see the second gif