Bristle Worm Trap

This is a remix of the bristle worm trap by TubbaButta based on the comments from that design.

I have removed four of the entry ports and added a bait trap at the end with the aim of catching larger worms. I managed to get three large (4 inches+) worms in one go, so it does work.

The lid is not included here as it's the same one from the original design.

I'd advise printing at 100% in-fill to reduce the odds of it floating away, but you'll likely need to put a couple of small rocks in it and use an elastic band to hold the lid on, but it's worth the effort.

I used sinking wafers as bait in mine as the worms seem to like them.