Thingiverse
Bronze Light
von Gothampixel
29
Downloads
41
Likes
2
Makes
This is just a test print. At this scale the wall thickness up top is .6mm in an attempt to make it as clear as possible.
This was my first attempt at switching filament mid print. The Base was printed in Colorfabb Bronzefill and the top is XT clear. XT requires a much higher printing temp so the transition wasn't as smooths as it could have been.
This was my first attempt at switching filament mid print. The Base was printed in Colorfabb Bronzefill and the top is XT clear. XT requires a much higher printing temp so the transition wasn't as smooths as it could have been.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
