Broom Holder

Customizable simple broom holder uses double sided tape or screws.

I like things super simple, so made this quick and easy broom holder.
It works great with 3M double sided tape.
All of my mops and brooms had different diameters, so I included the OpenSCAD file so you can set your own. I also provided STL files for a 20mm and 22mm diameter poles as these were the most common.
All the sizes and settings are easy to set.
The holes in the STLs were set to 1mm because I used a small nail, but you can set the screw hole diameter.
The holder_arc is set to 220 degrees, which feels good enough to hold the pole, yet not too tight to make it snap or pull off the wall with repeated use. You can set it as you like.

Printing:

I used a raft as you can see in the photo, but it may not be needed.