Thingiverse
Broom Wall Mount
por SassyTheSquatch
4
Descargas
2
Likes
0
Makes
Simple Broom holder wall mount.
This comes in two parts:
#The Outer Part:
The outer part is relatively simple, you can print it in any rigid material such as PETG or PLA. Just be sure to give it a relatively high infill, like 60%+.
#The Inner Part
The inner part is a bit tricky; Because I wanted to have a snap like effect, I designed the inner diameter to be a bit more narrower than the broom handle I had in mind then I printed it in a flexible material like TPU. Give it an infill of 10% or less (the higher the infill the harder it would be for the broom to slide in and out, I recommend 0%).
#After Printing
Simply glue the inner bit to the inside of the outer bit, drill a little hole in your wall or door of choice, and presto!
This comes in two parts:
#The Outer Part:
The outer part is relatively simple, you can print it in any rigid material such as PETG or PLA. Just be sure to give it a relatively high infill, like 60%+.
#The Inner Part
The inner part is a bit tricky; Because I wanted to have a snap like effect, I designed the inner diameter to be a bit more narrower than the broom handle I had in mind then I printed it in a flexible material like TPU. Give it an infill of 10% or less (the higher the infill the harder it would be for the broom to slide in and out, I recommend 0%).
#After Printing
Simply glue the inner bit to the inside of the outer bit, drill a little hole in your wall or door of choice, and presto!
SassyTheSquatch también publica en
5 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
