Thingiverse
Bruno_Cup
by juewei
6
Downloads
10
Likes
0
Makes
A small shotcup.
I was shown a 3D-print of this cup, and asked to print some more of them.
But then I could not find it here on thingiverse, nor elsewhere in reasonable time.
Re-creating it with FreeCAD 0.19 was a nice excercise.
It is composed of 3 bodies:
* The cup body itself is drawn as a half vertical crosssection spline, then rotated about the vertical axis.
* The handle is drawn as an elliptic crosssection and a travel path.
* A small box to cut away a part of the handle that extended into the inside of the cup.
Objects created from boolean operation of multiple bodies in FreeCAD-0.19 just work fine.
The cup is 31mm high, has 38mm outer diameter, and a wall thickness of ca 2.5 to 3mm.
May all your prints be watertight!
I was shown a 3D-print of this cup, and asked to print some more of them.
But then I could not find it here on thingiverse, nor elsewhere in reasonable time.
Re-creating it with FreeCAD 0.19 was a nice excercise.
It is composed of 3 bodies:
* The cup body itself is drawn as a half vertical crosssection spline, then rotated about the vertical axis.
* The handle is drawn as an elliptic crosssection and a travel path.
* A small box to cut away a part of the handle that extended into the inside of the cup.
Objects created from boolean operation of multiple bodies in FreeCAD-0.19 just work fine.
The cup is 31mm high, has 38mm outer diameter, and a wall thickness of ca 2.5 to 3mm.
May all your prints be watertight!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
