Thingiverse
Brushed Micro Quadcopter
von fureter
2
Downloads
5
Likes
0
Makes
Flights: https://youtu.be/P05rla9PyOM
Had some extra 8.5x20mm motors from a different project so I decided to take the electronics from my Beta75s and build a more powerful micro quad. This has a lot more power then the Beta75s (at the cost of lower flight times) and is a joy to fly.
Electronics:
Motor: 8.5x20mm 15000KV Brushed Motors
Props: Anbee 8pcs Propellers
FC: BETAFPV F4 FC 1S Brushed Flight Controller
Camera: Wolfwhoop WT07
Battery: Crazepony 4pcs 650mAh 1S Battery
Mass w/o Battery: 44g
Mass w/ Battery: 53g
Print:
•PLA or PETG (if PETG print with more wall perimeters)
•20% infill
•2 wall perimeters
•Use supports touching buildplate
•for other settings use printer/material recommended
Had some extra 8.5x20mm motors from a different project so I decided to take the electronics from my Beta75s and build a more powerful micro quad. This has a lot more power then the Beta75s (at the cost of lower flight times) and is a joy to fly.
Electronics:
Motor: 8.5x20mm 15000KV Brushed Motors
Props: Anbee 8pcs Propellers
FC: BETAFPV F4 FC 1S Brushed Flight Controller
Camera: Wolfwhoop WT07
Battery: Crazepony 4pcs 650mAh 1S Battery
Mass w/o Battery: 44g
Mass w/ Battery: 53g
Print:
•PLA or PETG (if PETG print with more wall perimeters)
•20% infill
•2 wall perimeters
•Use supports touching buildplate
•for other settings use printer/material recommended
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
