Brushed TinyWhoop Tricopter Concept

I got pretty close to done with this before I realized my setup isn't going to work. The idea was to have a brushed tricopter powered by a tiny whoop board. This is sized for a 9g micro servo because that's all I have at the moment; Unfortunately, it's also a 6 volt servo, and almost no brushed quadcopters are 2s. A low-voltage micro servo would work fine and fit right into place, but a low-voltage sub-micro servo would work even better, and I've parameterized as much as I can in the fusion 360 file. Moreover the only board I can feasibly do this with is brushless, so this was all dead in the water to begin with. I've got a low-voltage servo on the way, if that works with my setup I'll finish this, but with brushless motor hookups instead.


bill of materials:

1. 8mm motors
2. 40mm props
3. a brushed flight controller
4. a 9g servo
5. rubber damping grommets - something like these: https://www.amazon.com/gp/product/B075F7BVHV/ on the right.
6. AIO camera

The tail mounts