brushles 3d gimbal arms

This is a 3 pieces frame for a gimbal with brushless motors

i purchased the motors from aliexpress as well as the controller board

using an old alexmos 8bit controller on mine, or any other alexmos could work, it would all depend on your camera weight and current specs of the gimbal controller that you would choose

i was using a SL1 which is very light and it uses half of the max power without heating up, which would be the main enemy of this plastic build, i used carbon fiber fillament with excelent results, very little springyness, it works just fine, could be stronger with a different material maybe or a heat resistant plastic if you would want to get more power on small motors, currently using about 4.5cm diameter brushless motors

suggestions are to use a 32 bit controller with 2 imus because the 8 bit 1 imu that im using usually gets errors for being confused on which motor it should control after turning 20 degrees on any axis, regardless of that i think it does a bet