Thingiverse
Brushless Motor Vibration Table
von Taz85268
16
Downloads
15
Likes
0
Makes
I created this Brushless Motor Vibration Table so that I could balance my motors on a table instead of trying to do it on my Quad.
It can support up to 50mm Diameter Brushless Motors.
It needs standard Gimbal Vibration Balls (10mm Hole) X4
Best to go to Home Depot and get some Vinyl Bumpers to stick on the bottom and the top to keep it from moving around on the table and to protect your phone.
It was designed to fit up to 6 inch Spartphones.
Enjoy.
BTW... It would be nice to get a comment on this.
I would like to know from the community if you find this useful.
It can support up to 50mm Diameter Brushless Motors.
It needs standard Gimbal Vibration Balls (10mm Hole) X4
Best to go to Home Depot and get some Vinyl Bumpers to stick on the bottom and the top to keep it from moving around on the table and to protect your phone.
It was designed to fit up to 6 inch Spartphones.
Enjoy.
BTW... It would be nice to get a comment on this.
I would like to know from the community if you find this useful.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!