Brushless Whoop

-now with transport box
-uploaded a lighter stronger aerodynamic frame and some propguards for it
print the propquards in nylon
-the older version of the frame has to much surface so not much lift

Plan to make a 1s brushless Whoop 58 mm with 1102 10000Kv motors and the tinyfish combo.
http://www.boldclash.com/boldclash-fish01-f3-flight-controller-1s-4a-blheli-s-esc-tower-p6.html
Print the blue absorber for the 16x16 FC in flex.
-motor 1102 10000kv
-props gemfan 2035 cut down to 38mm
-lipo 1s 210-250mah powerwhoop connector
-flightimes arround 2:30 to 3:00 min
-4xM2x12 screws,4xM3nylon screw cut down for the flex absorber
-use only two screws per motor
-unscrew the motor next to the usb port to get the cable in :D
Camholder from fishpepper thx :D

-in betaflight board sensor alignment 45°yaw
-resource motor if necessary in cli dump