Thingiverse
Brutstruder Geared Stepper Mount
door JadeKnight
10
Downloads
38
Likes
2
Makes
This is used to mount a stepper motor to a Brutstruder. It was originally designed to use TheRuttmeister's 'older' gears ( thingiverse.com/thing:5164 ), however it could be adjusted to support any gear set you want. The stepper motor mounting holes have some 'slide' to them, so slightly different sized gears should work ok. I plan on updating this later to make sure it supports TheRuttmeister's new COLOSO-Gears ( http://www.thingiverse.com/thing:5795 ).
The OpenSCAD file contains references to the following STL files (used for the assembly view and reference only, no STL's are used in the actual construction of the stepper mount):
1. Gears from thingiverse.com/thing:5164
2. BrutStruder block and idler from thingiverse.com/thing:4036
3. Dino-2 L&R from thingiverse.com/thing:1912
Putting these STL's in the same folder as the OpenSCAD file will allow you to see the pieces in an assembled view (like the multi-colored image on the left).
UPDATE (02/07/11): Updated SCAD file, a
The OpenSCAD file contains references to the following STL files (used for the assembly view and reference only, no STL's are used in the actual construction of the stepper mount):
1. Gears from thingiverse.com/thing:5164
2. BrutStruder block and idler from thingiverse.com/thing:4036
3. Dino-2 L&R from thingiverse.com/thing:1912
Putting these STL's in the same folder as the OpenSCAD file will allow you to see the pieces in an assembled view (like the multi-colored image on the left).
UPDATE (02/07/11): Updated SCAD file, a
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
