Thingiverse
BSG 75 Coaster 100mm
37
Downloads
28
Likes
1
Makes
Simple print. Use white first and change filament to your color of choice.
If using 0.15mm layer height change filament at layer 8.
12/31/18 I fixed the letters so that thin line is gone and Cura slices it better. On mine, Cura ignored that line except on a few letters and it looked bad. I also increased the insides of the B so it prints a little more plastic there.
If using 0.15mm layer height change filament at layer 8.
12/31/18 I fixed the letters so that thin line is gone and Cura slices it better. On mine, Cura ignored that line except on a few letters and it looked bad. I also increased the insides of the B so it prints a little more plastic there.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
