Slicer Discord
3DSEARCH / Electronics / BT2.0 interface 1-6S charger
BT2.0 interface 1-6S charger – 3D printable model from MakerWorld MakerWorld
Electronics

BT2.0 interface 1-6S charger

by HUGH · Electronics
4 Downloads
2 Likes
1 Makes
Go to Model
最近在玩65小机，电池买了后发现没有买充电器，看了下充电器的价格就觉得挺离谱的。打算做一个模拟4S电池的线，但是这个不能够随意增减，只能按固定的数量充电。所以做出了这一次的1-6S可以随意切换的充电器。外壳前面是平衡头和XT头的出线口，后面的3毫米圆孔是引出一根线接一个BT2.0母头引出的母头是用来插到不用的充电口。比如说只有4块电池，BT2.0的母头插到5号位。一定一定接好线后，单插平衡头测试下每个接口能不能正常识别为我助力如果你觉得还不错，请给我一个助力需要购买物料6S平衡头线 1根 XT60/XT30母头 1个BT2.0公头 6个BT2.0母头 1个M2*10机螺丝 4个可选:16AWG线18AWG线下面是接线图（正负极之间的线可以用平衡头剪掉的多的线，但是建议用18AWG的线，太细的线能够承受的电流太低了）
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Flywoo EasyPower E16 1S box
Flywoo EasyPower E16 1S box
by M.Srnka
↓ 4
Microsquad 6 in 1 Charger Case V2
Microsquad 6 in 1 Charger Case V2
by Lennie
↓ 1 ♥ 4
Snap-on shell for HappyModel 1S USB Charger
Snap-on shell for HappyModel 1S USB Charger
by BenJuan26
↓ 10
Isdt E625 Battery charger holder
Isdt E625 Battery charger holder
by JakeFPV
↓ 6 ♥ 3
BetaFPV 1S Lipo Charger and Battery Holder (Tiny Whoop)
BetaFPV 1S Lipo Charger and Battery Holder (Tiny Whoop)
by TimBolton
↓ 116 ♥ 68
BETAFPV 1S LIPO CHARGER AND BATTERY HOLDER
BETAFPV 1S LIPO CHARGER AND BATTERY HOLDER
by DavidCanfield
↓ 39 ♥ 24
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
· Impressum · Privacy
DE EN FR ES IT NL

Add to Collection