BTT 1.4 Bear Case

I really should have posted this sooner. I made this case during the pandemic and apologize for being so late in posting. I tried to make the cable outputs fit the BTT board and this has been a workhorse in my Tall Bear. If you look at the cooling, you'll see that there are no vents on the build side. I had a problem with large PLA prints, where the air from the cooling fan warped the print near the case. The case is designed to vent most of the fan exhaust after it passes over the stepper drivers away from the printer. There are posts to help keep the stepper wiring out of the way. I also included an EPROM holder, that you can add to the case when printing. Please let me know if there's anything I can do to make the case better.