Thingiverse
BTT Smart Filament Runout Sensor Mount
von max-e-moose
29
Downloads
14
Likes
0
Makes
Having recently fitted support rods to my Ender 3 v2, it became clear that the BTT Smart Filament Run-out Sensor needed a new mounting point otherwise it would crash into the support rods near the top of the build volume.
This mount fixes to the rear plate for the X-axis. It uses two wheel nuts to stay in place.
There is roughly 11cm of PTFE tubing required to go from the sensor to the extruder block.
This mount fixes to the rear plate for the X-axis. It uses two wheel nuts to stay in place.
There is roughly 11cm of PTFE tubing required to go from the sensor to the extruder block.
max-e-moose veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
