Thingiverse
BTT Smart Filament Sensor Bracket for E3D Toolchanger
von digimatic
1
Downloads
0
Likes
0
Makes
Simple bracket to mount BTT Smart Filament Sensors onto the E3D Toolchanger without drilling the back panel.
Same Braket works on either side of the printer. Just add some M6 T Nuts and long M3 Screws (for the sensor clamps)
Same Braket works on either side of the printer. Just add some M6 T Nuts and long M3 Screws (for the sensor clamps)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
