Thingiverse
Bubble Shift Knob (Logitech) Remix
di Lock_RC
22
Download
16
Likes
0
Makes
A fix to J2J3J4's Bubble Shift Knob
Increased hole size to fit over shifter shaft.
Mating surface added inside the hole to interface with D-cut shaft to prevent spinning.
I didn't have a screw driver long enough to attempt to use the same fastener that's on the shifter already, but it is a good enough friction fit where the concern for the knob coming off is minimal.
Slight sanding needed to allow for a good fit between the two parts.
Increased hole size to fit over shifter shaft.
Mating surface added inside the hole to interface with D-cut shaft to prevent spinning.
I didn't have a screw driver long enough to attempt to use the same fastener that's on the shifter already, but it is a good enough friction fit where the concern for the knob coming off is minimal.
Slight sanding needed to allow for a good fit between the two parts.
Lock_RC pubblica anche su
18 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
