Bubbling Cauldron Dice Tower

It's that time of year again, where every GM is running a spooky one-shot! Spice it up by rolling the bones through this bubbling witch's cauldron dice tower. The interior is nice and wide, enough for 2 standard-sized d20s at a time, and I haven't had any problems yet with dice getting stuck. Dice come out the bottom and land in the ooze puddle.

This is quite large, so I printed it with just 5% infill. Make sure you have enough top layers to keep the surface smooth - I used 4 but probably should have gone for 5, some of the bubbles have little cracks where they transition from sides to top. I also used adaptive layer heights, which didn't have as much effect as I had liked. This would be a great use for non-planar printing if you have that capability. There's no supports necessary as long as you can do a little bit of bridging. Overall the print took a little over 13 hours. I had to sand off a few tiny bumps, but not many.