Buck Converter Case

I upgraded my Mainboard and Hotend Fans so I needed Converters from 24 to 12 Volt. One of the Converters fit into the mainboard Case but the other one was on the Outside with no special Case. So I went ahead and designed myself this little case.

Its a bit bigger than the digital Buck Converter, but it should be fine.

The files are separated into the case itself, the tabs for sliding it into the metal bars of the printer and the cover, which I once designed without and once with the clipping mechanism, so it stays on the box!

I hot glued the tabs to the bottom of the box and it works pretty well.
The Buck Converter can either be strung through the little holes at the bottom of the box or attached with glueing dough/pads