Budget Raised Bed Bracket System

I WOULD HEAVILY RECOMMEND TO PRINT IN ASA or ABS IF YOU HAVE ACCESS, PETG AND PLA MAY GET BRITTLE OR DEGRADE OVER A SEASON OR TWO HOWEVER YOUR MILAGE MAY VARY. USE DARKER COLORS OR PAINT FOR BEST UV RESISTANCE. I have not tested these in PLA/PLA+ however after about a year or two of an older model the PETG (which was in white so didn't help) started cracking and becoming brittle. YMMV based on your climate; these were used in Southern Virginia.Recommended Print SettingsI would recommend you set your infill to 15% or higher and 2 or more walls. Obviously the stronger the better however there is a balance to cost/performance. I recommend toying with your slicer settings to try and get it to kill a full roll for 8 or half a roll for 4. Supports are not required.You can also adjust the interlocking tightness by inducing elephants foot; I had a slightly different tolerance with ABS than I did ASA which caused the connection to be quite loose however I increased my bed temp and the lip c