Thingiverse
Bug-A-Salt Reservoir Hold Down
by cohocarl
12
Downloads
5
Likes
0
Makes
*For original Bug-A-Salt with round cover over salt.
The retaining clip on the cover of the salt reservoir on our Bug-A-Salt broke off and got tired of spilling salt all over the place, or messing with a rubber band wrapped around the charging handle.
As you can tell, I'm not an expert 3d modeler...kind of crude, but seems to work fine.
Print 2 and put a rubber band around the groove. Pretty easy to figure out.
P.S. If you haven't tried coarse Kosher salt in yours, give it a try.:)
This is a re-mix of my 1st Bug-A-Salt reservoir hold down model which had a couple failures on the vertical arms, so this one is beefed up a little.
(1st model: https://www.thingiverse.com/thing:3026249 )
The retaining clip on the cover of the salt reservoir on our Bug-A-Salt broke off and got tired of spilling salt all over the place, or messing with a rubber band wrapped around the charging handle.
As you can tell, I'm not an expert 3d modeler...kind of crude, but seems to work fine.
Print 2 and put a rubber band around the groove. Pretty easy to figure out.
P.S. If you haven't tried coarse Kosher salt in yours, give it a try.:)
This is a re-mix of my 1st Bug-A-Salt reservoir hold down model which had a couple failures on the vertical arms, so this one is beefed up a little.
(1st model: https://www.thingiverse.com/thing:3026249 )
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
