Thingiverse
BugZapperGutGuard
von BruceBach
0
Downloads
1
Likes
0
Makes
I found using a bug zapper in-doors shows how far the zapper throws the bugs. So I made this Bug guard to help catch the pieces.
This is for the DUNAGA Indoor/Outdoor Bug Zapper Model: T9:
https://www.amazon.com/dp/B0BZXTZ86P?psc=1&ref=ppx_yo2ov_dt_b_product_details
You need a 300mm printer or larger for this.
There are two sizes:
The small one is 250mm and can be doubled in the slicer to make both halves print at once.
The larger one is 300mm and needs to be rotated 45 degrees on a 300mm bed to fit. Print this one twice of course.
use 4 M4 x 20mm screws and the proper nuts and washers to mount them onto the zapper.
This is for the DUNAGA Indoor/Outdoor Bug Zapper Model: T9:
https://www.amazon.com/dp/B0BZXTZ86P?psc=1&ref=ppx_yo2ov_dt_b_product_details
You need a 300mm printer or larger for this.
There are two sizes:
The small one is 250mm and can be doubled in the slicer to make both halves print at once.
The larger one is 300mm and needs to be rotated 45 degrees on a 300mm bed to fit. Print this one twice of course.
use 4 M4 x 20mm screws and the proper nuts and washers to mount them onto the zapper.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!