Thingiverse
Build plate bender
von tonyal
0
Downloads
0
Likes
0
Makes
A stand for up to 30cm build plates that makes you able to bend a plate with one hand while trying to get printed models off the plate with the other hand.
Used laying down on a table but has a smaller footprint when stored in upright position.
Printed in standing position.
You can add a few extra support areas to prevent it from wobble while printing.
I printed mine without extra support.
New version:
The old one called "Bamboo 256x256 build plate bender" is designed with a notch in the middle of the back groove for the wiping zone.
The newer "Generic" version is thinner (down from 550g to 450g) and it doesn't have a notch for wiping zone(s).
Used laying down on a table but has a smaller footprint when stored in upright position.
Printed in standing position.
You can add a few extra support areas to prevent it from wobble while printing.
I printed mine without extra support.
New version:
The old one called "Bamboo 256x256 build plate bender" is designed with a notch in the middle of the back groove for the wiping zone.
The newer "Generic" version is thinner (down from 550g to 450g) and it doesn't have a notch for wiping zone(s).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
