Build Plate holder A1M (stackable & dustproof)

by disleik.design · 3D Printer Accessories

183 Downloads

82 Likes

114 Makes

and yet ANOTHER build plate holder.. ..this time for the A1 Mini! Stack it! ..or fully enclose it! It's up to you. The design is easy to print: Front & Rear facing down, and Sides on their sides.The holes are suited for 3x20mm hex-screws, but you can easily use shorter ones. ------------------------------ V0 = Capacity up to 4 plates (prints on A1 Mini)- V0: 1.2mm spacing for each plate.Fits all Standard (Engineering, Smooth, Textured, Cool) plates - V0 Extended:1.6mm spacing for each plate.Fits all Standard & Bambus new 3D Effect Plates. - V0 Xtreme:2.0mm spacing for each plate. Should fit any plate V2 = Capacity up to 5 plates ⚠ Does not print on A1 Mini ⚠ - V2 (Classic):1.2mm spacing for each plate.Fits all