Thingiverse
Buko-Spool 3
von maq3396
4
Downloads
2
Likes
1
Makes
An update from the previous Buko-Spool.
Still sits on top of a Bukobot like the previous one.
However uses a pair of R6-2RC bearings which are inexpensive and can be located on either ebay or amazon. The rod is 5/16 inch (could not find 3/8 at Home Depot and is 13 cm long. The two halves are held together with elastics and the weight of the spool keeps everything in place. Absolutely no resistance to filament delivery with this one!
Cheers and enjoy!
Mac
Still sits on top of a Bukobot like the previous one.
However uses a pair of R6-2RC bearings which are inexpensive and can be located on either ebay or amazon. The rod is 5/16 inch (could not find 3/8 at Home Depot and is 13 cm long. The two halves are held together with elastics and the weight of the spool keeps everything in place. Absolutely no resistance to filament delivery with this one!
Cheers and enjoy!
Mac
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!