Thingiverse
Bukobot 8 v2 Printer Spool Holding System
von Pacificimc
5
Downloads
4
Likes
0
Makes
Spool Holding System for the Bukobot 8 v2 Printer
With the rigid aluminum extrusion frame of the Bukobot 8 v2 we support our spool holding design.
Using 7/8 aluminum tubing, (1) sealed bearing and (2) fasteners.
The bearing is held by the Spool Holder Upper and lower Half's with a press fit (glue Optional). The only tool needed is for the fasteners.
You can customize the bearing tolerance on the aluminum tube by removing 0.002 - 0.003.
Solid and very little filament resistance…..
Thanks B
With the rigid aluminum extrusion frame of the Bukobot 8 v2 we support our spool holding design.
Using 7/8 aluminum tubing, (1) sealed bearing and (2) fasteners.
The bearing is held by the Spool Holder Upper and lower Half's with a press fit (glue Optional). The only tool needed is for the fasteners.
You can customize the bearing tolerance on the aluminum tube by removing 0.002 - 0.003.
Solid and very little filament resistance…..
Thanks B
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
