Thingiverse
Buldge test
von NikoG
8
Downloads
1
Likes
0
Makes
I designed this thing to find the source of a sort of buldge that occured sometimes.
I printed it 3x with the Slicer PE default settings (0.2mm, PLA), execpt for number of bottom layers=0 and infill = 10%. Orientation see screenshot, fill angle=default/45°.
It prints 8 gr in 30 minutes.
Variable was infill/perimeters overlap
25 % (default): big buldge
-10 %: small buldge
-30 % almost no bulde
We're closing in!
I printed it 3x with the Slicer PE default settings (0.2mm, PLA), execpt for number of bottom layers=0 and infill = 10%. Orientation see screenshot, fill angle=default/45°.
It prints 8 gr in 30 minutes.
Variable was infill/perimeters overlap
25 % (default): big buldge
-10 %: small buldge
-30 % almost no bulde
We're closing in!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!