MakerWorld
Electronics
Go to Model
Bullet Camera Flat Surface "Tripod" Holder
1
Downloads
0
Likes
0
Makes
I installed a few Yi Camera Outdoor cameras in my family's cottage, and some of them were not installed attached to a wall and needed to be installed flat on a surface, for that reason I need something to hold it in a certain orientation and tilted at a certain angle, so this “tripod” was designed. I used two ¼" hex nuts and two ¼" bolts to allow to change the tilt of the camera on a stable surface.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
