Thingiverse
Bullet Puzzle Base Stand
von Dennis-Q
14
Downloads
10
Likes
0
Makes
Designed up this base/stand for the existing Bullet Puzzle found on Thingiverse:
https://www.thingiverse.com/thing:43672
The goal was a simple stand to keep all pieces together, and in my case also personalize it for a special occasion with some text added to the side.
It was created by taking the bullet diameter and add just a bit to make it fit. It is really a tight fit and the bullets won't fall out if you turn it upside down. After the first time use it will be easier to take them out.
Printing: No supports, minimal infill (15% was sufficient in my case). I do have 3 layers of walls by default but less will do I guess. Standard quality (0.2mm layers)
About 11 grams.
https://www.thingiverse.com/thing:43672
The goal was a simple stand to keep all pieces together, and in my case also personalize it for a special occasion with some text added to the side.
It was created by taking the bullet diameter and add just a bit to make it fit. It is really a tight fit and the bullets won't fall out if you turn it upside down. After the first time use it will be easier to take them out.
Printing: No supports, minimal infill (15% was sufficient in my case). I do have 3 layers of walls by default but less will do I guess. Standard quality (0.2mm layers)
About 11 grams.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
