Bunk Bottle Holder

A simple drink bottle holder for my daughters bunk bed.

The holder has an 85mm hole and is 125mm deep. It has two parts, the bottle holder and the mount.

The holder and mount do not have to be glued, but I glued them so if the holder is separated from the mount by my daughter I am not spending any time reassembling them.

The bed it was designed for has a slope on it at the position were the holder would mount, so to enable the hold to be level the mount has a step in it. If the bed you have does not have the same slope or no slope the step can be cut off or removed.

If the bed you have has an entirely different mount requirement you can design your own mount and attach it to the bottle holder via the dove-tale detail.

Note: No structural design or review was conducted during the designing of this bottle holder other than a brain, eye ball guess. To date (~6 months) this holder has remained in place and has not presented any danger or hazard to any body or anything. Tha