Thingiverse
Bunny Pot
by bobross96
7
Downloads
24
Likes
0
Makes
This is a modified version of https://www.thingiverse.com/thing:752379
A bunny pot! A bit of a pain to print, I recommend 0% infill, 0.6mm layer height and a 0.8mm nozzle, with at least a 0.3mm gap at the support interface. may print better with organic supports. Make sure to enforce no supports on the inside of the watering tube, as they're really hard to remove. Might also be a good idea to enable ironing so the bottom of the pot is actually waterproof.
The "pot" part is a little small, but would work nicely for a succulent.
A bunny pot! A bit of a pain to print, I recommend 0% infill, 0.6mm layer height and a 0.8mm nozzle, with at least a 0.3mm gap at the support interface. may print better with organic supports. Make sure to enforce no supports on the inside of the watering tube, as they're really hard to remove. Might also be a good idea to enable ironing so the bottom of the pot is actually waterproof.
The "pot" part is a little small, but would work nicely for a succulent.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
