MakerWorld
Architecture
Go to Model
Burj Khalifa
2.5k
Downloads
608
Likes
997
Makes
As the largest building in the world, I also wanted to include it in my collection. There are already some models, but I thought I'd give it a try. In the end, it wasn't quite that easy. In 1:1000, the tower is already quite considerable in size Printer settingExtrusion width (over all): 0.4Perimeter generator: Classic Support:Only required below the main entrance roofs at Part 1. Notes:The connections might be a little too big, but that depends on the printer. Otherwise, either glue or put some tape around the individual connectors to give them a better fit.
vandragon_de also publishes on
109 additional models across 4 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
