Thingiverse
Engineering
Ver Modelo
Bus Blaster V4.1a case
1
Descargas
1
Likes
0
Makes
This is a simple case I made for the Bus Blaster V4.1a. (http://dangerousprototypes.com/docs/Bus_Blaster#Bus_Blaster_v4)
I did not find any available so I did one.
It is as small as I think is possible.
I recommend that the lid is flipped up side down when printing.
The need for support is minimal and depending on the bridging capabilities of your printer.
I used it only in the USB port.
I did not find any available so I did one.
It is as small as I think is possible.
I recommend that the lid is flipped up side down when printing.
The need for support is minimal and depending on the bridging capabilities of your printer.
I used it only in the USB port.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
