Thingiverse
busines card holder
por paulokareka
7
Descargas
11
Likes
0
Makes
PT-Br
Corrigido o erro que estava apresentando de o circulo inferior não deixava o restante da peça tocar a mesa.
Se estiver usando o Simplify3D, deve ir em malha e em separar as superfícies, pois caso contrario ele ira deixar onde esta o circulo sem preenchimento.
EN
Fixed the error that was showing that the lower circle did not let the rest of the piece touch the table.
If you are using Simplify3D, you should go in mesh and separate the surfaces, otherwise it will leave the circle where it is without filling.
Corrigido o erro que estava apresentando de o circulo inferior não deixava o restante da peça tocar a mesa.
Se estiver usando o Simplify3D, deve ir em malha e em separar as superfícies, pois caso contrario ele ira deixar onde esta o circulo sem preenchimento.
EN
Fixed the error that was showing that the lower circle did not let the rest of the piece touch the table.
If you are using Simplify3D, you should go in mesh and separate the surfaces, otherwise it will leave the circle where it is without filling.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!