Thingiverse
Butterfly Earring Stand
von AndinBriwel
46
Downloads
68
Likes
0
Makes
My first upload!
This is a decorated earring stand with a dish as the base for use at the bedside or bathroom counter. A handy place to put your things when you remove them, or in preparation for tomorrow :)
The upright inserts into the base via 2 square posts. The tolerance is a clearance fit, so if your printer is printing inside and outside dimensions accurately, it will fit together. If not, you may need to tweak your settings to get those inside hole dimensions printing accurately, or just sand the posts a bit.
Have fun!
This is a decorated earring stand with a dish as the base for use at the bedside or bathroom counter. A handy place to put your things when you remove them, or in preparation for tomorrow :)
The upright inserts into the base via 2 square posts. The tolerance is a clearance fit, so if your printer is printing inside and outside dimensions accurately, it will fit together. If not, you may need to tweak your settings to get those inside hole dimensions printing accurately, or just sand the posts a bit.
Have fun!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
