Butterfly Napkin Rings

Stunning napkin rings with a cute butterfly design. Perfect for the upcoming spring/summer to use as table decorations :) Each ring uses about 15g of filament (including supports) and takes around 85 minutes to print. The time is mainly due to the high level of detail and the ironing finish. Print Settings For best results, follow the recommended settings below. Supports are needed for this model, but requires very little filament use. 0.12 mm layer height 15% infill 3 walls Top surface ironing Bottom supports Filament Used Winkle PLA (Pastel purple) Sunlu (Pink) All feedback, ideas and requests are very welcome!