Thingiverse
Button Battery LED Holder
door jeramyshouston
25
Downloads
36
Likes
1
Makes
A button cell (specifically for CR 2032) battery holder, designed to attach an LED diode directly to it. This is a remix/redesign of the Atomseeker's design available here:
https://www.printables.com/model/289171-2025-coin-cell-battery-led-light
His design was for a smaller button cell. Mine are sized up to the 2032. Print in place upright, no supports needed. Feed the legs of the LED diode through the two holes in the rear of the holder, with the positive lead on the positive side of the holder. Hot glue the diode in place. The battery is friction held in place by the diode legs.
Used in the attached pictures is a battery and flickering LED scavenged from a flameless candle tea light available at in packs at any dollar store.
https://www.printables.com/model/289171-2025-coin-cell-battery-led-light
His design was for a smaller button cell. Mine are sized up to the 2032. Print in place upright, no supports needed. Feed the legs of the LED diode through the two holes in the rear of the holder, with the positive lead on the positive side of the holder. Hot glue the diode in place. The battery is friction held in place by the diode legs.
Used in the attached pictures is a battery and flickering LED scavenged from a flameless candle tea light available at in packs at any dollar store.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
